DESCRIPTION
It is a cement-based, frost-resistant, hydraulically hardening, thin-bed tile adhesive with high frost
resistance, reduced slip properties, and long working time. It is classified as C2TE according to
FIELDS OF APPLICATION
• Interior and exterior bonding of all types of ceramic tiles (thin porcelain tiles, single-fired,
double-fired, clinker, bricks, etc.) and mosaics on floors, walls and ceilings
• Suitable for spot bonding of insulating materials such as expanded polyurethane, expanded
polystyrene and glass wool, sound-deadening panels, etc.
• Bonding of tiles on places subject to heavy traffic, such as offices,
shopping malls,hospitals and schools.
PROPERTIES
• Can be applied on vertical surfaces even for bonding of heavy tiles without sagging.
• Easily trowelable.
• Perfect adherence.
• Can be used with ceramic tiles up to size of 40*40 cm
PREPARATION AND SUBSTRATES
• The surface to be applied must be cleaned of dust, dirt, formwork oil, and paint that may prevent adhesion.
• Cracked plasters and weak surfaces that cannot support themselves should be scraped off.
• Damaged surfaces and cracks should be repaired with suitable
HG MORTAR F or HG MORTAR T repair mortars.
• Depending on the absorbency of the surface, it should be primed
with TP or TILE PRIMER before application.
• For better adhesion on fair-faced concrete surfaces,
the surface should be primed with BETON CONTACT.
APPLICATION
Preparing the mix
20 kg of SUPER MASTER should be slowly poured into 6,5-7.5 liters of water and mixed with a
low-speed drill until a homogeneous mixture is obtained.
The prepared mortar should be left to mature for 5-10 minutes and then mixed again for 1-2 minutes
before being applied to the surface
Applying the mix
Apply SUPER MASTER to the substrate with a suitable trowel. The selection of the correct trowel

depends on the evenness of the substrate, the size of the tile and the profile of the back.
It is not necessary to wet the tiles before setting. Only when the backs are very dusty is it advisable
to dip the tiles in clean water
Spread the mortar onto the substrate with a notched trowel of which notch size is appropriate to he
tile dimension.
Open time is 30 minutes.Install the tiles whitin this period with a firm pressure. Unfavourable
weather conditions (strong sun, wind, high temperature) may shorten the open time, sometimes
quite drastically, to just a few minutes.
GROUTING AND SEALING
Joints between the tiles can be grouted for Wall after 8 hours and for floor 24 hours with the
specific PANTHERA cementitious or epoxy grouts, available in different colours. Expansion joints must be
sealed with the specific PANTHERA sealants.
Consumption
• Approximately 3-4 kg/m2 with a 6 mm notched trowel
• Approximately 2-5 kg/m2 with an 8 mm notched trowel
• Approximately 5-6 kg/m2 with a 10 mm notched trowel
Material requirements depend on the quality of the base surface, tile, and processing method.
Post-Application Maintenance and Recommendations
• Re-mixing the used material or reprocessing already hardened waste material is prohibited!
• ±Always comply with applicable standards and directives.
• Clean tools and mixing containers immediately after use, as the material can only be removed
mechanically once hardened.
• Avoid contact with eyes or skin! In case of contact, rinse thoroughly with plenty of water and
consult a specialist if necessary.
For any questions during the construction process, please contact our experts!,